If you are a baseball player, you will need to have a clear understanding of how to replace the grip of it. Then you will be able to make sure that you don’t need to depend on anyone else to get the grip replaced. As a result, you can ensure top performance at all times as well.

How to apply

Below mentioned are the steps that you must follow when you are replacing the grip of the Easton S650 bat. This procedure can be followed when replacing the grip of almost any Easton bat as well.

1. To begin off, you will have to keep the baseball bat on a firm and a solid surface. On your baseball bat, you can let the grip hang off from the edge. Therefore, it would be better to use a table for the entire process. Now you will need to create a line on the top of baseball bat grip. This can be done with the assistance of a marker. As the next step, you will have to take out a utility knife and cut the tape with the positions where you indicated with a marker. Then you can peel off your old grip in the baseball bat.

2. Now you have come to the second step of replacing the baseball bat grip. Before you proceed, you will have to put on the gloves. Then you can keep paper towels below your bat so that you can easily catch the residues. Now you can apply one of the residue cleaners on the handle of the baseball bat so that you will be able to get rid of residue. After that, you can simply scrub off residue from the bat.

3. As the third step, you should grab a chair and hold the bat between the legs firmly. Then you can keep the knob upwards and start wrapping. You can start wrapping from the knob of your baseball bat and then proceed with spiral motion until you come towards the mark.

4. Once the pre-wrapping process is completed, you will need to hold the baseball bat in the same position, while sitting on the chair. Then you have to put an electrical tape on top of the previous wrapping. You have to follow the same motion as well. However, you must be careful that the new layer is applied evenly on top of the old layer.

5. Now you have come to the last step. In here, you will need to apply a small electrical tape piece at the beginning as well as at the end of the bat, so that you can fasten it.

Now you have a clear understanding of the steps that you must follow when wrapping the bat. Hence, you just need to move forward with the process. If you follow these steps, wrapping the grip of an Easton bat will be a hassle-free experience to you.

Author's Bio: 

I am adam jordan. Writing is my passion.