How to use diamond tech tile

A diamond tech tile saw is essential for cutting natural stone tile and other hard tile. Here you will get the opportunity by dupont stonetech professional explains how to make tough cuts like curves, corners and tiny slivers.

Here's no substitute for a diamond tech tile saw when you have to make fine cuts—corners, curves, slivers—or cut stone or other hard tiles. In this article, we'll show you how a tile pro makes the tricky cuts that result in a first-class job. Tile-cutting diamond wet saws are available at rental stores, some large home centers and tile stores that cater to DIYers.

Set the saw up outside or in your garage or workshop. If a finished room is more convenient, cover the floor and wall behind the saw with plastic dropcloths. Then fill the tub with water.

Even though the tile saw looks scary, the blade is abrasive rather than toothed and therefore safer than wood-cutting saws. You'll still want to take precautions, as you would with any other saw.
Mark the tile with a lead or grease pencil. Set the tile against the fence on the sliding saw bed and line up the diamond blade with the cutting mark. Turn on the saw and wait for water to flow over the blade. Hold the tile on both sides of the cutting line and slowly feed it into the blade. As the cut nears completion, gently push the two halves of the tile together to prevent the tile from breaking before the cut is complete. When the cut is complete, carefully slide the bed and cut tile back toward you until the tile is clear of the blade.

Wait for a stream of water to cover the blade before you start cutting. Watch the line as you cut and slightly adjust the position of the tile to keep the blade on the line. Move the tile slowly through the blade for the best-quality cut. If you hear the saw slow down, you're cutting too fast. Harder materials require slower feed rates. When you finish the cut, keep both hands on the tile and slide the table back and clear of the blade before you reach to switch off the saw.