Common Joints Used In Joinery In Sydney

There is nothing quite like owning a piece of furniture, cabinetry or fixture that has been custom created for your home through experienced joinery in Sydney – not only is the piece highly functional, it is a perfect fit for the space it was created for. When dealing with a joinery firm in Sydney, however, you may hear the contractors talking about a lot of joints that you don’t understand. This is a basic guide to common joints used in joinery in Sydney.

Basic Butt
This is the most common type of joinery in Sydney, but it does have a reputation for being one of the weakest joints. Basically, it is created when one piece of wood butts into another (at a right angle) and the two are glued together.

Biscuit
A joinery method in Sydney for connecting wood along the edges, this joint involves slots being cut into the edge of the wood. Thin, wooden ‘biscuits’ are inserted into these slots and glued into place to hold the two boards together.

Dado
In Sydney, this joinery method is created by cutting a square grooved slot into a piece of wood, allowing room for another piece to slide into place.

Dovetail
A favourite method of joinery in Sydney, this process involves cutting the end of a piece of wood so that it resembles the turrets on a castle. The opposite of this pattern is cut into a second piece of wood, allowing the two boards to slot together perfectly.

Half Lap
This method of joinery in Sydney is also fairly simple – half of the width of two pieces of wood is removed so that they may join flush together. Considered much stronger than a butt joint, the wood is then glued into place.

Mortise and Tenon
This is a classic method of joinery in Sydney and involves a hole (known as a mortise) being cut into one piece of wood so that a smaller piece of wood (known as a tenon) can fit into it.

Pocket
This method of joinery in Sydney refers to a slot being cut and a pilot hole being pre-drilled at an angle between two pieces of wood. A screw is then used to connect the two boards.

Tongue and Groove
In Sydney, this joinery method describes the process of connecting two pieces of wood along one edge, creating a much wider board. This joint is much stronger than just gluing the two boards together, as there is more surface area touching.

Now that you understand some of the most common joints used in joinery in Sydney, you will be well prepared to understand what exactly it is that your joiner is talking about during your next project.