Repairing Sink Cabinets- Why It’s a Professional Carpenter’s Job?

It’s a well-known fact that sink cabinets are prone to natural degradation and rot if not maintained properly. A minor leak in the enclosed area is sufficient to weaken the structural integrity of the cabinets and cause the particle board to sag and vertical walls to detach at a premature stage. While replacing the cabinets may seem to be the easiest solution to the problem, however, it's a time-taking and expensive. This article will explain the tips you need to know for repairing damaged sink cabinets and why professional contractors are best fitted for the job.

Basic Tools You Need

• ½ plywood
• Stain polyurethane paint
• Small brush

Before plunging into the task, it’s wise to install new plywood over the decayed floor as this can solve a couple of issues at once. It holds the cabinet in place and eliminates the need of removing the countertop.

Here are the easiest hacks recommended by professional carpenters for repairing sink cabinets effortlessly.

Fix Plumbing Modifications

99% of cabinet sink issues are a result of plumbing failure. Leaking drainage, broken gaskets and damaged water supply lines contribute to water deposition in the confines of your cabinet interiors and result in premature decay. Modern cabinets are often manufactured with low-grade materials that absorb water and make the problem run rampant before you could even realise it. So before attempting to repair, it’s important to fix plumbing modifications by contractors offering carpentry repair services Ipswich to ensure everything is in order.

Take Cabinet Measurements

Once you are done making necessary plumbing adjustments, take measurements of your cabinet interiors to get a substitute for adjusting the space gap. You just need ½ plywood to make up the lag. The repairing process can be a bit complicated and challenging as you won’t be able to fit a full-sized piece because of the space divider. In that case, you may need to install the new floor into two separate pieces by professional carpenters to fill the centre.

Cut Holes for Pipes

There are two ways you can handle the cuts. The easier one is none other than using saw bits. The circular saw bits easily chuck into the drill and cut holes by spinning. Saw bits come in varied sizes and if you have hole saw-toothed bits, you may select ones that are slightly bigger than the diameter of your pipes for cutting holes.

Join the Panels

Remove both the panels from your cabinet and run a thick layer of premium construction adhesive around the perimeter of the outdated floor. Secure the panels back in place with due care and attention and then push them down into their point of origin. However, make sure you don't drop adhesives on the faces of new panels. Spread a bead of adhesive on the joining points of both panels as this would hold them firmly.

Attach the Main Face Trim

You will notice the edge of the new panel will gradually become visible from the front which may look a bit unsightly initially. Avoid leaving your plywood exposed by concealing it with a thin trim strip. Cut a piece of pine trim slightly more than a consistent thickness of ply panel and attach it between the centre divider and outer panel of the face frame.

Hope you have got a fair idea of how intricate is the process of repairing damaged sink cabinets and why skilled carpenters are best fitted for the job. If you find this post helpful, share your feedback with us. We would love to hear from you!